408-10390

Rev M1

2 of 18

Figure 2

Each applicator is individually designed for specific terminals. The wire crimp height and insulation crimp height

can be adjusted to accommodate different wire sizes and insulation ranges, respectively. The applicator is also

designed to accept modular-feed packages. The feeder assembly can be removed from the applicator and

replaced with any different style; mechanical, air, or servo feed; depending on the requirements (see Figure 3).

To change to a different feed type, use retro-fit kit PN 2119949 for the mechanical terminal feeder, retro-fit kit

PN 2119950 for the pneumatic terminal feeder, and retro-fit kit PN 2119951 for the servo terminal feeder.

Figure 3

Air Feed Applicator

Feed Arm

Feed Backstroke/Rear Position

Adjustment

Feed Pawl

Mounting Screw

(2 Places)

Air Feed Cam

Air Supply Connection

Detent Screw

(2 Places)

End Cap Bolt

(2 Places)

End Cap

Feed Stroke/Feed Forward Position

Adjustment

Forward Speed Control

Retract Speed Control

Changing Feeder Assembly

Servo Terminal

Feeder Assembly

Pneumatic Terminal

Feeder Assembly

Servo Feeder Latch Plate

Push Rod

Bushing

Applicator

Mechanical Terminal

Feeder Assembly