©2011 Tyco Electronics Corporation, Berwyn, PA

All Rights Reserved

TE logo and Tyco Electronics are trademarks.

*Trademark. Other products, logos, and company names might be trademarks of their respective owners.

Instruction Sheet

TOOLING ASSISTANCE CENTER 1-800-722-1111

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.tycoelectronics.com

1 of 6

LOC B

NEVALO* Interconnect System

Hand Crimping Tool Kit 2161090-1

408-10413

06 JAN 11 Rev A

PROPER USE GUIDELINES

Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use

and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.

Figure 1

1. INTRODUCTION

NEVALO Interconnect System Hand Crimping Tool Kit

2161090-1 (Figure 1) is designed to prepare cable and

crimp connectors for the new NEVALO Interconnect

System.

This document is intended to provide application and

maintenance procedures for the tool kit. For

information relating to the NEVALO Interconnect

System, consult Application Specification 114-13290.

Read these instructions thoroughly before installing

dies and using the tool kit.

This tool kit features a short handle PRO-CRIMPER

Hand Tool (2119991-1), a Cable Notching Tool

(2119990-1), and two interchangeable die sets.

Hand Tool 2119991-1 will only accept Tyco

Electronics dies that are designed for use with the

NEVALO Interconnect System.

The dies are designed for quick and tool-less

installation and removal. The short handle

PRO-CRIMPER Hand Tool (2119991-1) has two pins

installed in the die mounting area to retain the dies.

Select the desired die assembly and proceed as

follows:

NOTE

i

Multi-Nest Die

Right-Angle Die

Short Handle

PRO-CRIMPER*

Tool

Cable Notching

Tool

Hand Crimping Tool

Kit 2161090-1