408-10413

4 of 6

Rev A

Figure 6

4. Place the notched ribbon cable in the

connector with the notch being aligned with the

connector post. See Figure 5B.

5. Place the base half of the connector in the die

nest. See Figure 5C.

6. Hold the ribbon cable steady while squeezing

the hand tool handles.

7. Release the handles to open the hand tool.

8. Remove the crimped connector from the die

set.

1. Install the multi-nest die set (blue dot) into the

hand tool as specified in Section 3.

2. Place the connector in the die set nest as

shown in Figure 6.

The TE logo should be facing the moving jaw of the

hand tool.

3. Place the prepared ribbon cable fully into the

connector.

4. Squeeze the hand tool handles while keeping

the ribbon cable fully inserted into the connector.

5. Release the handles to open the hand tool.

6. Remove the crimped connector from the die

set.

1. Install the multi-nest die set (blue dot) into the

hand tool as specified in Section 3.

Figure 7

NOTE

i