408-32145

Rev A

2 of 5

1. Open the tool handles and remove the two die retaining screws from the tool jaws.

2. Slide the die assembly into the partially opened tool jaws.

3. Insert the die retaining screws and tighten the screws just enough to hold the dies in place. Do not

tighten the screws completely at this time.

4. Carefully close the tool handles, making sure the dies align properly. Continue closing the tool handles

until the ratchet in the tool frame has engaged sufficiently to hold the die in place, then tighten both die

retaining screws.

5. To disassemble, close the tool handles until the ratchet releases, remove the two die retaining screws,

and slide the dies out of the tool jaws.

Figure 2

4. CRIMPING PROCEDURE

NOTE

Before using the tool, the crimping chamber and tool ratchet should be inspected as specified in Paragraph 5.2, Measuring Die

Opening, and Paragraph 5.3, Ratchet Adjustment.

Strip cable according to the proper dimensions and assemble the connector to the cable according to the

instructions in the appropriate connector instruction sheet. Then proceed as follows:

1. Place connector in the nest die so that the edge of the connector is flush with the edge of the die. See

Figure 3.

2. Holding the assembly in place, close the tool handles until the ratchet releases.

3. Remove the crimped assembly from the crimping die.

Figure 3

Tool Frame

Anvil Die

Nest Die

Die Retaining

Screws

Connector in

Nest Die

Ferrule Flush with Edge of

Die Set (Or See Specific

Connector Instruction Sheet

for Placement)