Electronic Components Datasheet Search |
|
576718-8 Datasheet(PDF) 1 Page - TE Connectivity Ltd |
|
576718-8 Datasheet(HTML) 1 Page - TE Connectivity Ltd |
1 / 5 page Instruction Sheet 1 of 5 © 2016 TE Connectivity Ltd. family of companies. All Rights Reserved. *Trademark TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners. PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.te.com. 408-10039 01 JUL 16 Rev D Figure 1 1. INTRODUCTION The terminal crimping dies listed in Figure 1 are designed to be used with hand tool 69710-1 to crimp PIDG STRATO-THERM terminals onto wire sizes 24 through 10 AWG. Refer to instruction sheet 408-2095 for information concerning the hand tool. For other compatible tooling, call the number at the bottom of this page. Reasons for re-issue of this instruction sheet are provided in Section 7, REVISION SUMMARY. 2. DIE INSTALLATION AND REMOVAL 1. Position the stationary die in the stationary die holder and the moving die in the moving die holder of the tool. Turn each die holding screw just enough to hold the dies in place. Do not tighten the screws. 2. Position a terminal and wire in the dies as described in steps 1 through 3 of Section 3, then close the tool handles until the dies bottom. 3. Tighten both the die holding screws while dies are bottomed. NOTE Check die alignment and tighten the die holding screws at least twice daily. 4. Continue to close the tool handles until the ratchet control releases. Allow the handles to open, then remove the terminal. 5. To remove the dies, loosen the die holding screws. 3. CRIMPING 1. Strip the wire to the dimension provided in Figure 2. 2. Place the terminal in the stationary die as shown in Figure 3, then close the tool handles until the terminal is held firmly in place. NOTE These dies will not accommodate a terminal having a tongue width exceeding 11.91 mm [.469 in.]. 3. Insert the stripped wire into the terminal insulation barrel until the wire butts against the locator. PROPER USE GUIDELINES Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available. PIDG* STRATO-THERM* Terminal Crimping Dies Crimping Dies 576711, 576714, 576715, 576716, 576720, 576723, 576742 Die Holding Screw Moving Die Stationary Die Insulation Adjustment Spacers (Shown in Position 3) Die Holding Screw Color Code Color Code |
Similar Part No. - 576718-8 |
|
Similar Description - 576718-8 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |