Electronic Components Datasheet Search |
|
843473-1 Datasheet(PDF) 1 Page - Tyco Electronics |
|
843473-1 Datasheet(HTML) 1 Page - Tyco Electronics |
1 / 2 page Instruction Sheet 408-9451 LOC B 1 of 2 E2008 Tyco Electronics Corporation, Harrisburg, PA All International Rights Reserved TE logo and Tyco Electronics are trademarks. *Trademark. Other products, logos, and company names used are the property of their respective owners. TOOLING ASSISTANCE CENTER 1-800-722-1111 PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.tycoelectronics.com 07 MAR 08 Rev C ExtractionTool 843473-1 Figure 1 Wire Contact Locking Lance Lance Recess Tip AMPMODU* MOD IV Receptacle Connector Front of Connector Locking Ledge AMPMODU MOD I Receptacle Connector Lug 1. INTRODUCTION This instruction sheet covers the use of Extraction Tool 843473–1 which is recommended for removing crimp, snap–in contacts from AMPMODU MOD I and MOD IV Receptacle Connectors listed in Catalog 1307819. Read these instructions before attempting to extract the contacts. All dimensions are in millimeters [with inches in brackets]. Figures are for reference only and are not drawn to scale. Reasons for reissue are given in SECTION 5, REVISION SUMMARY. 2. DESCRIPTION The extraction tip is designed to enter the lance recess in the front of the housing and depress the locking lance of the contact. The connector includes both the housing and the contacts while the housing is the material which forms the encapsulation for the contacts. The lance recess is the cavity located between the contact and the connector housing. A solid rib (locking ledge) at the rear of the lance recess cavity provides a stop for the extraction tool. The housings are designed to prevent improper insertion of the contacts which are inserted into the rear of the housing. A lug is located on the side of the MOD I housing which contains the contact locking ledge. 3. EXTRACTION PROCEDURE (Figure 1) Determine which connector contains the contact to be removed and proceed as follows: 1. Insert the tool straight into the lance recess until it bottoms on the locking ledge. 2. Holding the tool and connector in one hand, grip the wire of the contact with the other hand and pull the contact out of the back of the connector. NOTE i NOTE i |
Similar Part No. - 843473-1 |
|
Similar Description - 843473-1 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |