Electronic Components Datasheet Search |
|
1583237-1 Datasheet(PDF) 1 Page - Tyco Electronics |
|
1583237-1 Datasheet(HTML) 1 Page - Tyco Electronics |
1 / 2 page Instruction Sheet 408-8646 LOC B 1 of 2 E2009 Tyco Electronics Corporation, Harrisburg, PA All International Rights Reserved TE logo and Tyco Electronics are trademarks. *Trademark. Other products, logos, and company names used are the property of their respective owners. TOOLING ASSISTANCE CENTER 1-800-722-1111 PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.tycoelectronics.com 09 FEB 09 Rev A Extraction Tool 1583237-1 Figure 1 Adjustment Cap Handle Push Pin Spring-Loaded Tip 1. INTRODUCTION Extraction Tool 1583237–1 (shown in Figure 1) is designed to extract individual pin (post) contacts from HM–Zd header connectors. The connectors can be removed from the printed circuit (pc) board using HM–Zd Header Removal Tools 1583220–1 and 1583234–1 (refer to 408–8645). Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Figures are not drawn to scale. Read these instructions before using the extraction tool. Reasons for reissue of this instruction sheet are provided in Section 6, REVISION SUMMARY. 2. DESCRIPTION The extraction tool consists of a handle, adjustment cap, spring–loaded tip, and push pin. See Figure 1. The adjustment cap, located on one end of the handle, can be set to allow the push pin to recess or extend out of the spring–loaded tip while extracting the pin contact. The push pin pushes on the pin contact and ejects it from the pc board and connector. 3. EXTRACTION PROCEDURE 3.1. Pin Contact Not Extended Beyond Board Surface 1. Turn the adjustment cap clockwise until the push pin is extended (approximately 0.51 [.020]) beyond the end of the spring–loaded tip. Refer to Figure 2. Figure 2 Push Pin Extended 0.51 [.020] Approx Spring-Loaded Tip Handle 2. With the push pin extended, locate the appropriate pc board hole (in the back side of the pc board) of the pin contact to be extracted, and place the push pin into the hole. Refer to Figure 3. Figure 3 Extended Push Pin Aligned with Pin Contact Hole Back Side of PC Board Connector 3. Holding the tool perpendicular to the pc board, apply pressure to the tool until the pin contact is ejected from the pc board and connector. It may be necessary to raise the pc board off the work surface to allow for sufficient clearance of the extracted pin contact. NOTE i NOTE i |
Similar Part No. - 1583237-1 |
|
Similar Description - 1583237-1 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |