Datasheet

www.rohm.com

TSZ02201-0RAR1G200270-1-2

© 2013 ROHM Co., Ltd. All rights reserved.

6/33

12.Sep.2013 Rev.001

TSZ22111･15･001

BU7265G

BU7265SG

BU7266xxx

BU7266Sxxx

Description of Electrical Characteristics

Described below are descriptions of the relevant electrical terms used in this datasheet. Items and symbols used are also

shown. Note that item name and symbol and their meaning may differ from those on another manufacturer’s document or

general document.

1. Absolute maximum ratings

Absolute maximum rating items indicate the condition which must not be exceeded. Application of voltage in excess of absolute

maximum rating or use out of absolute maximum rated temperature environment may cause deterioration of characteristics.

(1) Supply Voltage (VDD/VSS)

Indicates the maximum voltage that can be applied between the VDD terminal and VSS terminal without

deterioration or destruction of characteristics of internal circuit.

Indicates the maximum voltage that can be applied between non-inverting and inverting terminals without damaging

the IC.

Indicates the maximum voltage that can be applied to the non-inverting and inverting terminals without deterioration

or destruction of electrical characteristics. Input common-mode voltage range of the maximum ratings does not assure

normal operation of IC. For normal operation, use the IC within the input common-mode voltage range characteristics.

Indicates the power that can be consumed by the IC when mounted on a specific board at the ambient temperature 25℃

the package (maximum junction temperature) and the thermal resistance of the package.

2. Electrical characteristics

Indicates the voltage difference between non-inverting terminal and inverting terminals. It can be translated into the

input voltage difference required for setting the output voltage at 0 V.

Indicates the difference of input bias current between the non-inverting and inverting terminals.

Indicates the current that flows into or out of the input terminal. It is defined by the average of input bias currents at

the non-inverting and inverting terminals.

Indicates the current that flows within the IC under specified no-load conditions.

Indicates the voltage range of the output under specified load condition. It is typically divided into maximum output

voltage High and low. Maximum output voltage high indicates the upper limit of output voltage. Maximum output

voltage low indicates the lower limit.

Indicates the amplifying rate (gain) of output voltage against the voltage difference between non-inverting terminal

and inverting terminal. It is normally the amplifying rate (gain) with reference to DC voltage.

Av = (Output voltage) / (Differential Input voltage)

Indicates the input voltage range where IC normally operates.

(8) Common-mode Rejection Ratio (CMRR)

Indicates the ratio of fluctuation of input offset voltage when the input common mode voltage is changed. It is

normally the fluctuation of DC.

CMRR = (Change of Input common-mode voltage)/(Input offset fluctuation)

(9) Power Supply Rejection Ratio (PSRR)

Indicates the ratio of fluctuation of input offset voltage when supply voltage is changed.

It is normally the fluctuation of DC.

PSRR= (Change of power supply voltage)/(Input offset fluctuation)

The maximum current that can be output from the IC under specific output conditions. The output source current

indicates the current flowing out from the IC, and the output sink current indicates the current flowing into the IC.

(11) Slew Rate (SR)

Indicates the ratio of the change in output voltage with time when a step input signal is applied.

Indicates a frequency where the voltage gain of operational amplifier is 1.

(13) Phase Margin (

θ)

Indicates the margin of phase from 180 degree phase lag at unity gain frequency.

(14) Channel Separation (CS)

Indicates the fluctuation in the output voltage of the driven channel with reference to the change of output voltage of

the channel which is not driven.