07 | Keysight | FieldFox Handheld Analyzers 4/6.5/9/14/18/26.5/32/44/50 GHz - Data Sheet

Frequency

Spec

Typical

N991xA, N992xA

95

100

> 9 to 14 GHz

91

97

> 14 to 18 GHz

90

94

> 18 to 20 GHz

87

90

> 20 to 25 GHz

74

79

> 25 to 26.5 GHz

65

70

N995xA

> 300 kHz to 1 MHz

—

70 (nominal)

> 1 to 10 MHz

—

100 (nominal)

100

110

90

100

81

90

Cable and Antenna Analyzer and Vector Network Analyzer (continued)

System performance specifications

Temperature stability

Nominal

Frequency

Magnitude (dB/ºC)

Phase (deg/ºC)

N991xA, N992xA

≤ 15 GHz

± 0.018

—

> 15 to 26.5 GHz

± 0.080

—

N995xA

≤ 15 GHz

± 0.005

± 0.1

≤ 25 GHz

± 0.030

± 0.3

> 25 GHz

± 0.060

± 0.6

1. System dynamic range is measured in factory with loads on test ports after thru normalization, test port output power high.

2. For CAT mode, “Insertion loss (2-port)”, decrease listed dynamic range specifications by 20 dB, as CAT mode IFBW is fixed at 10 kHz. Can obtain full

dynamic range by using S21 measurement in VNA mode with 100 Hz IFBW.

3. < 300 kHz: 63 dB nominal; 2 to 9 MHz: 85 dB spec, 90 dB typical.

4. Decrease by 3 dB between 15 to 15.8 GHz for S21.

5. Decrease by 5 dB between 21.7 to 22.1 GHz for S21.

6. Decrease by 4 dB between 44 to 50 GHz for S21.

7. 850 μs /pt; applicable for FieldFox with serial number prefix < than MY5607/SG5607/US5607 and FieldFox not upgraded with Option

N9910HU-100/200/300.

8. 850 μs /pt; applicable for FieldFox with serial number prefix < than MY5607/SG5607/US5607 and FieldFox not upgraded with Option

N9910HU-100/200/300/400.

Measurement speed (Sweep time)

CAT

N991xA, N992xA

N995xA

433 μs /pt

—

Return loss, 300 kHz to 50 GHz, 1-port cal, 1001 points

—

650 μs /pt

480 μs /pt

650 μs /pt

VNA

N991xA, N992xA

N995xA

S11 and S21, 30 kHz to 26.5 GHz, enhanced response cal,

483 μs /pt

—

S11 and S21, 300 kHz to 50 GHz, enhanced response cal,

100 kHz IF bandwidth, 1001 points

—

580 μs /pt