Medical Grade 150 Watt Open Frame with PFC

WWW.ASTRODYNETDI.COM

ASTRODYNE USA: 1-800-823-8082

ASTRODYNE PACIFIC: 886-2-26983458

INPUT SPECIFICATIONS

Input Voltage Range

90-264 VAC (100-240VAC nom.)

Frequency Range

47-63 Hz

Power Factor Correction

0.96 min. at nom. Input

Inrush Current, typ at cold start: 30A @ 115VAC

Leakage Current

<0.3mA @ 264VAC, 50Hz

OUTPUT SPECIFICATIONS

Voltage and Current (Note 6)

See Selection Chart

Line Regulation (Note 8)

See Selection Chart

Load Regulation (20%-FL)

Singles: ± 1%, max.

Cross Regulation (note 7)

Duals: ±3/5%

Preset Accuracy (Note 9)

±1%, typ

Over Voltage Protection

130% max. of nom. input

Auto Recover after fault condition

Over Current Protection

150% max. of FL at nom. input

Short Circuit Protection

Auto Recover after fault

Hold Up Time

20mS, typ (Nom I/P, FL)

GENERAL SPECIFICATIONS

Isolation (Note 4)

I/P-O/P: 5656VDC

I/P-Ground: 2828VDC

O/P-Ground: 707VDC

Efficiency

75%,min.atnom.input

Safety UL/cUL:

ANSI/AAMI ES60601-1 3rd ed.

CSA C22.2 No. 60601-1 3rd ed.

UL-EU:

EN60601-1 3rd ed.

CB:

IEC60601-1 3rd ed.

CE:

EN60601-1-2

ENVIRONMENTAL SPECIFICATIONS

Oper. Temperature

-10 to +70°C

(See Derate Curve)

Storage Temperature

Relative Humidity

EMC

EN55011 Class B

MTBF

270,000 Hrs

Mil Std 217, 25°C

PHYSICAL SPECIFICATIONS

Size

3” x 5.5” x 1.437”

Construction

Open Frame

Weight

1.0 lb, (454g)

NOTES

may adversely affect long term reliability. Proper operation under conditions

other than the standard operating conditions is neither warranteed nor implied.

All specifications are typical at nominal input, full load, and 25°C unless other-

wise noted

1. All measurements should be made directly at the terminals of the

power supply

2.Allspecificationstypical@25°C,unlessotherwisenoted,at

nominal line and load.

3.Rippleandnoisedependentuponoutputvoltageasspecifiedper

particular model.

4. Isolation for up to 1 minute duration.

5.Specifiedforfreeairconvectioncooling.

6. Minimum load is not required for proper operation.

7. Load Regulation is measured by change ±40% of measured

output load from 60% full load, with the other output set to 60% full

load.

8. Line Regulation measured from 90-264VAC. 100VAC minimum

required for full load start.

9. Preset Accuracy measured at nominal load, 120VAC input.

10. O/P Noise measured directly at the pins/terminals at nominal load,

0.1uF bypass and 47uF electrolytic, pk-pk @ 20MHz bandwidth.