DC/DC Converter for IGBT Driver

QA Series

2015.06.03-B/0

Page 5 of 5

MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation

Notes:

bag number: 58200013;

2. The lead wire connecting the power supply module and IGBT driver should be as short as possible during use;

3. The output filtering capacitor should be as close as possible to the power supply module and IGBT driver;

4. The peak of the IGBT driver gate drive current is high, so low internal resistance electrolytic capacitor is recommended to be used for

the power supply module output filter capacitor;

5. The average output power of the driver must be lower than that of the power supply module;

6. Consider fixing in place with glue near the module if being used in vibration occasions;

7. The maximum capacitive load offered were tested at nominal input voltage and full load;

8. Unless otherwise specified, parameters in this datasheet were measured under the conditions of Ta=25℃, humidity<75% with nominal

input voltage and rated output load;

9. All index testing methods in this datasheet are based on our Company’s corporate standards;

10. The performance parameters of the product models listed in this manual are as above, but some parameters of non-standard model

products may exceed the requirements mentioned above. Please contact our technicians directly for specific information;

11. We can provide product customization service;

12. Specifications are subject to change without prior notice.

MORNSUN Guangzhou Science & Technology Co., Ltd.

Address: No. 5, Kehui St. 1, Kehui Development Center, Science Ave., Guangzhou Science City, Luogang District, Guangzhou, P. R. China

Tel: 86-20-38601850-8801

Fax: 86-20-38601272

E-mail: info@mornsun.cn