Electronic Components Datasheet Search |
|
TC7135 Datasheet(PDF) 11 Page - Microchip Technology |
|
TC7135 Datasheet(HTML) 11 Page - Microchip Technology |
11 / 22 page © 2002 Microchip Technology Inc. DS21460B-page 11 TC7135 5.3 BUSY Output At the beginning of the signal integration phase, BUSY goes high and remains high until the first clock pulse after the integrator zero crossing. BUSY returns to the logic "0" state after the measurement cycle ends in an overrange condition. The internal display latches are loaded during the first clock pulse after BUSY and are latched at the clock pulse end. The BUSY signal does not go high at the beginning of the measurement cycle, which starts with the auto zero cycle. 5.4 OVERRANGE Output If the input signal causes the reference voltage integra- tion time to exceed 20,000 clock pulses, the OVER- RANGE output is set to a logic "1." The overrange output register is set when BUSY goes low and is reset at the beginning of the next reference integration phase. 5.5 UNDERRANGE Output If the output count is 9% of full scale or less (-1800 counts), the underrange register bit is set at the end of BUSY. The bit is set low at the next signal integration phase. 5.6 POLARITY Output A positive input is registered by a logic "1" polarity sig- nal. The polarity bit is valid at the beginning of refer- ence integrate and remains valid until determined during the next conversion. The polarity bit is valid even for a zero reading. Signals less than the converter's LSB will have the signal polar- ity determined correctly. This is useful in null applications. 5.7 Digit Drive Outputs Digit drive signals are positive-going signals. The scan sequence is D5 to D1. All positive pulses are 200 clock pulses wide, with the exception D5, which is 201 clock pulses wide. All five digits are scanned continuously, unless an overrange condition occurs. In an overrange condition, all digit drives are held low from the final STROBE pulse until the beginning of the next reference integrate phase. The scanning sequence is then repeated. This provides a blinking visual display indication. 5.8 BCD Data Outputs The binary coded decimal (BCD) bits B8,B4,B2, and B1 are positive-true logic signals. The data bits become active at the same time as the digit drive signals. In an overrange condition, all data bits are at a logic "0" state. |
Similar Part No. - TC7135 |
|
Similar Description - TC7135 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |