L10C11JC15 datasheet(4/6 Pages) LODEV

Part #	L10C11JC15

Description	4/8-bit Variable Length Shift Register

Download	6 Pages

Scroll/Zoom	100%

Manufacturer	LODEV [LOGIC Devices Incorporated]

Direct Link	http://www.logicdevices.com

Logo

4 / 6 page

DEVICES INCORPORATED

L10C11

4/8-bit Variable Length Shift Register

Pipeline Registers

03/27/2000–LDS.11-L

4

1. Maximum Ratings indicate stress

specifications only. Functional oper-

ation of these products at values be-

yond those indicated in the Operating

Conditions table is not implied. Expo-

sure to maximum rating conditions for

extended periods may affect reliability.

2. The products described by this speci-

fication include internal circuitry de-

signedtoprotect the chipfrom damaging

substrate injection currents and accumu-

lations of static charge. Nevertheless,

conventional precautions should be ob-

served during storage, handling, and use

of these circuits in order to avoid expo-

sure to excessive electrical stress values.

3. Thisdeviceprovideshardclampingof

transient undershoot and overshoot. In-

put levels below ground or above VCC

will be clamped beginning at –0.6 V and

VCC

+ 0.6 V. The device can withstand

indefinite operation with inputs in the

range of –0.5 V to +7.0 V. Device opera-

tion will not be adversely affected, how-

ever, input current levels will be well in

excess of 100 mA.

4. Actual test conditions may vary from

those designated but operation is guar-

anteed as specified.

5. Supply current for a given application

can be accurately approximated by:

where

N = total number of device outputs

C = capacitive load per output

V = supply voltage

F = clock frequency

6. Tested with all outputs changing ev-

ery cycle and no load, at a 5 MHz clock

rate.

7. Tested with all inputs within 0.1 V of

VCC

or Ground, no load.

8. These parameters are guaranteed

but not 100% tested.

NCV F

4

2

NOTES

9. AC specifications are tested with

input transition times less than 3 ns,

output reference levels of 1.5 V (except

tDIS

test), and input levels of nominally

0 to 3.0 V. Output loading may be a

resistive divider which provides for

specified IOH and IOL at an output

voltage of VOH min and VOL max

respectively.

Alternatively, a diode

bridge with upper and lower current

sources of IOH and IOL respectively,

and a balancing voltage of 1.5 V may be

used. Parasitic capacitance is 30 pF

minimum, and may be distributed.

This device has high-speed outputs ca-

pable of large instantaneous current

pulses and fast turn-on/turn-off times.

As a result, care must be exercised in the

testing of this device. The following

measures are recommended:

a. A 0.1 µF ceramic capacitor should be

installed between VCC and Ground

leads as close to the Device Under Test

(DUT) as possible. Similar capacitors

should be installed between device VCC

and the tester common, and device

ground and tester common.

b. Ground and VCC supply planes

must be brought directly to the DUT

socket or contactor fingers.

c. Input voltages should be adjusted to

compensate for inductive ground and VCC

noise to maintain required DUT input

levels relative to the DUT ground pin.

10. Each parameter is shown as a min-

imum or maximum value. Input re-

quirements are specified from the point

of view of the external system driving

the chip. Setup time, for example, is

specified as a minimum since the exter-

nal system must supply at least that

much time to meet the worst-case re-

quirements of all parts. Responses from

the internal circuitry are specified from

the point of view of the device. Output

delay, for example, is specified as a

maximum since worst-case operation of

any device always provides data within

that time.

11. For the tENA test, the transition is

measured to the 1.5 V crossing point

with datasheet loads. For the tDIS test,

the transition is measured to the

±200mV level from the measured

steady-state output voltage with

±10mA loads. The balancing volt-

age, VTH, is set at 3.5 V for Z-to-0

and 0-to-Z tests, and set at 0 V for Z-

to-1 and 1-to-Z tests.

12. These parameters are only tested at

the high temperature extreme, which is

the worst case for leakage current.

S1

IOH

IOL

VTH

CL

DUT

OE

0.2 V

tDIS

tENA

0.2 V

1.5 V

3.5V Vth

1

Z

0

Z

1

Z

0

1.5 V

0V Vth

VOL*

VOH*

VOL*

VOH*

Measured VOL with IOH = –10mA and IOL = 10mA

Measured VOH with IOH = –10mA and IOL = 10mA

FIGURE B. THRESHOLD LEVELS

FIGURE A. OUTPUT LOADING CIRCUIT

Similar Part No. - L10C11JC15

Manufacturer	Part #	Datasheet	Description
Powerbox	L10	646Kb / 1P	1.5W - 3KV SINGLE & DUAL OUTPUT DC/DC INDUSTRIAL
Linear Technology	L10-0112	313Kb / 24P	100VIN Micropower Isolated Flyback Converter with 150V/260mA Switch
Linear Technology	L10-0116	313Kb / 24P	100VIN Micropower Isolated Flyback Converter with 150V/260mA Switch
EUROQUARTZ limited	L10.7	45Kb / 1P	CERAMIC FILTERS
ECS, Inc.	L10.7	145Kb / 1P	CERAMIC FILTER

More results

Similar Description - L10C11JC15

Manufacturer	Part #	Datasheet	Description
Nippon Precision Circui...	SM5829P	231Kb / 8P	High-speed, 8-bit Variable-length Shift Register
Nippon Precision Circui...	SM5830P	228Kb / 8P	High-speed, 8-bit Variable-length Shift Register
Fairchild Semiconductor	TMC2011A	69Kb / 12P	Variable-Length Shift Register
Cadeka Microcircuits LL...	TMC2011A	179Kb / 12P	Variable-Length Shift Register
Nippon Precision Circui...	SM5824N	143Kb / 6P	Variable Length Static Shift Register
ON Semiconductor	MC14557	90Kb / 8P	1-to-64 Bit Variable Length Shift Register June, 2004 ??Rev. 5
Nexperia B.V. All right...	HEF4557B	755Kb / 16P	1-to-64 bit variable length shift register Rev. 7 - 1 April 2016
NXP Semiconductors	HEF4557B	78Kb / 7P	1-to-64 bit variable length shift register January 1995
Motorola, Inc	MC14557B	206Kb / 6P	1-TO-64 BIT VARIABLE LENGTH SHIFT REGISTER
Hitachi Semiconductor	HD14557B	75Kb / 5P	1-to-64-bit Variable Length Shift Register

More results

L10C11JC15 Datasheet(PDF) 4 Page - LOGIC Devices Incorporated

L10C11JC15 Datasheet(HTML) 4 Page - LOGIC Devices Incorporated

Similar Part No. - L10C11JC15

Similar Description - L10C11JC15

Html Pages

1 2 3 4 5 6

Datasheet Download

Link URL