www.RFM.com

E-mail: info@rfm.com

Page 1 of 1

©2008 by RF Monolithics, Inc.

WIT910DK - 3/19/08

Benefits:

• Simple to set-up and configure

• Complete with all components to put a system “on the air”

• Enclosed units contain rechargeable battery supply

• Accelerates the integration process

• Full technical support included with purchase

• Allows development of interface to your system

• Allows development of your control software

OEM Module

Developer’s

Kits

WIT2410SDK

Developer’s Kits Contents:

• 2 ea. Enclosed Desktop Modem

• 2 ea. OEM Module

• 2 ea. 4” RF Cable

• 4 ea. Right Angle Rubber Flex

Antenna

• 2 ea. Power / Data Cable

• 2 ea. Wall Mount Power Supply/

Charger

• Configuration Software

• Integration Guide

OEM Module Developer’s Kits: Ordering Information

OEM Module

Developer’s Kit Part No.

Description

WIT910

WIT910DK

WIT910 Developers Kit

WIT2410

WIT2410DK

WIT2410 Developer’s Kit

WIT2410SDK

WIT2410 SNAP Developer’s Kit:

Includes the SNAP2410 Access Point

WIT2411

WIT2411DK

WIT2411 Developer’s Kit

WIT5811

WIT5811DK

WIT5811 Developer’s Kit

WIT2450

WIT2450DK

WIT2450 Developer’s Kit

Each WIT OEM Module Developer’s Kits contain two selfcontained wireless modems built around specific

OEM modules. Additionally, two OEM modules are included in the kit. The self-contained units allow

developers to get up and running quickly using standard RS-232 interfaces without having to build a 3.3V

level serial interface. The self-contained modems include LEDs to provide modem status information visually,

and a built-in rechargeable battery pack allows the developer to use the modems without being tethered to a

power source. This provides a simple way to test the range of the radios. Other than the true RS-232 signals

of the serial interface, the self-contained modems operate exactly as the OEM modules.

Connection is made to the modem through a standard DB-9 connector. The modems are set up as a DCE

device requiring the use of a straight-through cable to connect to DTE devices. The modems can be used

with a three-wire connection; transmit data, receive data, and ground are the three required connections.

Note that in this configuration, no flow control is available as the OEM Modules do not support software flow

control.

When the developer’s kit is shipped from the factory, one modem is set up as a base station and the other is

set up as a remote. However, with the supplied configuration software, this configuration can be modified to

suit your particular application. Refer to the bottom of this sheet for individual kits.