High Voltage 2-Electrode Gas Discharge Tube (GDT)

3 / 4

@SOCAY Electronics Co., Ltd. 2014

Specifications are subject to change without notice.

Please refer to www.socay.com for current information.

UN2E8 / UN2H8 Series

SOCAY Electronics Co., Ltd.

www.socay.com

Item

Test Condition / Description

Requirement

DC Spark-over Voltage

The voltage is measured with a slowly rate of rise dv / dt=100V/s

Impulse Spark-over Voltage

The maximum impulse spark-over voltage is measured with a rise time of

dv / dt=100V//

μs or 1KV/μs

Insulation Resistance

The resistance of gas tube shall be measured each terminal each other

terminal,

please see above spec.

Capacitance

The capacitance of gas tube shall be measured each terminal to each other

terminal.

Test frequency :1MHz

Nominal Impulse Discharge

Current

The maximum current applying a waveform of 8/20

μs that can be applied

across the terminals of the gas tube. One hour after the test is completed,

re-testing of the DC spark-over voltage does not exceed

±30% of the nominal

DC spark-over voltage. Dwell time between pulses is 3 minutes.

To meet

the specified

value

Solder Iron Temperature: 350

°C +/-5°C

Heating Time:

5 seconds max.

Electrical Rating

Recommended soldering profile

Wave soldering

Soldering profile applied a single process

Reflow soldering

Soldering Parameters - Hand Soldering

1.0

0.9

0.5

0.1

0.0

20

μsec

30% Max

T

I

8

μsec