LP3879

SNVS396B – MAY 2006 – REVISED APRIL 2013

www.ti.com

For these reasons, X7R and X5R type ceramic capacitors must be used on the input and output of the

LP3879.

SHUTDOWN INPUT OPERATION

The LP3879 is shut off by pulling the Shutdown input low, and turned on by pulling it high. If this feature is not to

To assure proper operation, the signal source used to drive the Shutdown input must be able to swing above and

below the specified turn-on/turn-off voltage thresholds listed in the Electrical Characteristics section under

REVERSE INPUT-OUTPUT VOLTAGE

The PNP power transistor used as the pass element in the LP3879 has an inherent diode connected between

the regulator output and input.

During normal operation (where the input voltage is higher than the output) this diode is reverse-biased.

However, if the output is pulled above the input, this diode will turn ON and current will flow into the regulator

output.

which can damage the part.

In any application where the output may be pulled above the input, an external Schottky diode must be

0.3V (see Absolute Maximum Ratings).

10

Submit Documentation Feedback

Copyright © 2006–2013, Texas Instruments Incorporated

Product Folder Links: LP3879