TLP2408

3

7.

7.

7.

7. Absolute Maximum Ratings (Note)

Absolute Maximum Ratings (Note)

Absolute Maximum Ratings (Note)

Absolute Maximum Ratings (Note)

LED

Detector

Common

Characteristics

Forward current

Forward current derating

Reverse voltage

Power dissipation

Power dissipation derating

Output current

Output current

Output voltage

Supply voltage

Operating temperature

Storage temperature

Lead soldering temperature

Isolation voltage

(10 s)

AC, 1 min, R.H. ≤ 60%

Symbol

Note

(Note 1)

Rating

25

-0.67

5

40

-1.0

25/-15

5/-5

-0.5 to 20

-0.5 to 20

-40 to 100

-55 to 125

260

3750

Unit

mA

mA/

V

mW

mW/

mA

V



Vrms

Note:

Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the

significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even

if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum

ratings.

Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook

("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test

report and estimated failure rate, etc).

Note 1: This device is considered as a two-terminal device: Pins 1, 2, 3 and 4 are shorted together, and pins 5, 6, 7

and 8 are shorted together.

8.

8.

8.

8. Recommended Operating Conditions (Note)

Recommended Operating Conditions (Note)

Recommended Operating Conditions (Note)

Recommended Operating Conditions (Note)

Characteristics

Input on-state current

Input off-state voltage

Supply voltage

Operating temperature

Symbol

Note

(Note 1)

Min

2

0

4.5

-40

Typ.









Max

10

0.8

20

100

Unit

mA

V



Note:

The recommended operating conditions are given as a design guide necessary to obtain the intended

performance of the device. Each parameter is an independent value. When creating a system design using

this device, the electrical characteristics specified in this datasheet should also be considered.

Note:

A ceramic capacitor (0.1 µF) should be connected between pin 8 and pin 5 to stabilize the operation of a high-

gain linear amplifier. Otherwise, this photocoupler may not switch properly. The bypass capacitor should be

placed within 1 cm of each pin.

Note 1: Denotes the operating range, not the recommended operating condition.

2010-08-12

Rev.1.0