DS_E48SC3R320_05182011

11

THERMAL CONSIDERATIONS

Thermal management is an important part of the system

design. To ensure proper, reliable operation, sufficient

cooling of the power module is needed over the entire

temperature range of the module. Convection cooling is

usually the dominant mode of heat transfer.

Hence, the choice of equipment to characterize the

thermal performance of the power module is a wind

tunnel.

Thermal Testing Setup

Delta’s DC/DC power modules are characterized in

heated vertical wind tunnels that simulate the thermal

environments

encountered

in

most

electronics

equipment. This type of equipment commonly uses

vertically mounted circuit cards in cabinet racks in which

the power modules are mounted.

The

following

figure

shows

the

wind

tunnel

characterization setup. The power module is mounted

on a test PWB and is vertically positioned within the

wind tunnel. The space between the neighboring PWB

and the top of the power module is constantly kept at

6.35mm (0.25’’).

Note: Wind Tunnel Test Setup Figure Dimensions are in millimeters and (Inches)

12.7 (0.5”)

MODULE

AIR FLOW

50.8 (2.0”)

FACING PWB

PWB

AIR VELOCITY

AND AMBIENT

TEMPERATURE

MEASURED BELOW

THE MODULE

Figure 20: Wind tunnel test setup

Thermal Derating

Heat can be removed by increasing airflow over the module.

To enhance system reliability; the power module should

always be operated below the maximum operating

temperature. If the temperature exceeds the maximum

module temperature, reliability of the unit may be affected.

THERMAL CURVES

Figure 21: Hot spot temperature measured point.

E48SC3R320 (standard) Output Current vs. Ambient Temperature and Air Velocity

@Vin=48V (Transverse Orientation)

0

4

8

12

16

20

25

30

35

40

45

50

55

60

65

70

75

80

85

Output Current (A)

Ambient Temperature

(℃)

Natural

Convection

100LFM

200LFM

300LFM

400LFM

500LFM

600LFM

Figure 22: Output current vs. ambient temperature and air velocity