You are facing difficulties refilling your ink cartridges or require more information about the refilling procedure? Please feel free to contact us. The address is as follow:

Logos, brand names and product descriptions are the property of their respective manufacturers and are used for reference purposes only.

Refill instructions Epson T0611 | T0612 | T0613 | T0614 | T0615

Please carefully read these instructions before refilling your ink cartridges. Always carry out the ink refill process on a dirt resistant mat and have a moist cloth to hand to quickly

remove any ink spillage. The instructions apply only to the ink cartridges referred to above. The syringe and ink should be kept away from children. We accept no responsibility for

any damage caused by inadequate or incorrect actions carried out during the refilling process. The refilling of ink cartridges is carried out at your own risk. An empty ink cartridge

of this type can be refilled with approximately 8 ml of ink.

In order to refill an ink cartridge, a syringe filled with

ink is required. Open the cap of one of the enclosed ink

holders, which also acts as a syringe. Now insert the

enclosed blunt needle using a twisting motion into the

opening. Hold the lower part of the ink holder with your

thumb and forefinger and twist it counter clockwise into

the appliance.

Then seal the ink outlet opening with an adhesive

tape and place the ink cartridge in an upright position.

Next, using the tool provided, drill a hole approximately

7 mm deep through the designated opening. Drill carefully,

as there are 2 inner walls to drill through.

3.

2.

Now insert the syringe into the newly made opening and

fill the ink chamber slowly and carefully until just below

the opening. Should some of the ink leak out, simply

remove it by using the syringe.

Seal the newly drilled hole with an adhesive strip and

then leave the ink cartridge for a few hours to allow the

ink enough time to spread throughout the ink chamber.

Finally, the ink cartridge chip ink fluid level reading needs

to be reset. In order to do this, press the reset device

(not included with the refill kit set) pins against the ink

cartridge chip contact. After removing the adhesive tape

from the ink outlet area, the refilled ink cartridge can

then be inserted into the printer. Please be aware of the

possibility of ink leakage.

6.

5.

4.

1.