Optoway

XPS-2341W-DXXG

***********************************************************************************************************************************************************************

**********************************************************************************************************************************************************************

Tel: 886-3-5979798

Fax: 886-3-5979737

E-mail: sales@optoway.com.tw

http: // www.optoway.com.tw

7/1/2010

V1.0

7

Power down; When high, requires the module to limit power consumption to 1.5W or

below. 2-Wire serial interface must be functional in the low power mode.

21 LVTTL-I

P_Down/RST

Reset; The falling edge initiates a complete reset of the module including the 2-wire

serial interface, equivalent to a power cycle.

22

VCC2

+1.8V Power Supply (Not required)

3

23

GND

Module Ground

1

24 PECL-I

RefCLK+

Reference Clock Non-Inverted Input, AC coupled on the host board. (Not used.

Internally terminated to 50 ohm (100 ohm diff.))

4

25 PECL-I

RefCLK-

Reference Clock Inverted Input, AC coupled on the host board. (Not used. Internally

terminated to 50 ohm (100 ohm diff.))

4

26

GND

Module Ground

1

27

GND

Module Ground

1

28 CML-I

TD-

Transmitter Inverted Data Input

29 CML-I

TD+

Transmitter Non-Inverted Data Input

30

GND

Module Ground

1

1. Module ground pins GND are isolated from the module case and chassis ground within the module.

2. Shall be pulled up with 4.7K-10Kohms to a voltage between 3.15V and 3.45V on the host board.

3. These PINs are open within module.

4. A Reference Clock input is not required. If present, it will be ignored.

MECHANICAL SPECIFICATION (UNITS IN MM)