W78L52

Publication Release Date: January 1999

- 5 -

Revision A2

FUNCTIONAL DESCRIPTION

The W78L52 architecture consists of a core controller surrounded by various registers, five general

purpose I/O ports, 256 bytes of RAM, three timer/counters, one watchdog timer and a serial port. The

processor supports 111 different opcodes and references both a 64K program address space and a

64 K data storage space.

Timers 0, 1, and 2

Timers 0, 1, and 2 each consist of two 8-bit data registers. These are called TL0 and TH0 for Timer

0, TL1 and TH1 for Timer 1, and TL2 and TH2 for Timer 2. The TCON and TMOD registers provide

control functions for timers 0, 1. The T2CON register provides control functions for Timer 2. RCAP2H

and RCAP2L are used as reload/capture registers for Timer 2. The operations of Timer 0 and Timer

1 are the same as in the W78L51. Timer 2 is a special feature of the W78L52: it is a 16-bit

timer/counter that is configured and controlled by the T2CON register. Like Timers 0 and 1, Timer 2

can operate as either an external event counter or as an internal timer, depending on the setting of

bit C/T2 in T2CON. Timer 2 has three operating modes: capture, auto-reload, and baud rate

generator. The clock speed at capture or auto-reload mode is the same as that of Timers 0 and 1.

Clock

The W78L52 is designed to be used with either a crystal oscillator or an external clock. Internally, the

clock is divided by two before it is used. This makes the W78L52 relatively insensitive to duty cycle

variations in the clock.

Crystal Oscillator

The W78L52 incorporates a built-in crystal oscillator. To make the oscillator work, a crystal must be

connected across pins XTAL1 and XTAL2. In addition, a load capacitor must be connected from each

pin to ground, and a resistor must also be connected from XTAL1 to XTAL2 to provide a DC bias

when the crystal frequency is above 24 MHz.

External Clock

An external clock should be connected to pin XTAL1. Pin XTAL2 should be left unconnected. The

XTAL1 input is a CMOS-type input, as required by the crystal oscillator. As a result, the external clock

Power Management

Idle Mode

The idle mode is entered by setting the IDL bit in the PCON register. In the idle mode, the internal

clock to the processor is stopped. The peripherals and the interrupt logic continue to be clocked. The

processor will exit idle mode when either an interrupt or a reset occurs.

Power-down Mode

When the PD bit of the PCON register is set, the processor enters the power-down mode. In this

mode all of the clocks, including the oscillator are stopped. The only way to exit power-down mode is

by a reset.

Reset

The external RESET signal is sampled at S5P2. To take effect, it must be held high for at least two

machine cycles while the oscillator is running. An internal trigger circuit in the reset line is used to

deglitch the reset line when the W78L52 is used with an external RC network. The reset logic also has