 |
 |
|
| FKC10 |
|
|||||||||||
 MAKE-PS
|
| |||||||||||
|
2 page 
www.make-ps.com E-mail:info@make-ps.com Input Specifications Output Specifications General Specifications Recommended Test Circuit Suggest adding input external filter(C1,C2,L)to meet conducted emissions (En55022 class A) 2/3 Parameters Conditions Min Typ Max Units Voltage Types 2:1 Filter Pi Network Protection Fuse Recommended Parameters Conditions Min Typ Max Units Voltage Tolerance Single/Dual ± 2 % Short Circuit/ Restart Continuous/ Automatic Over Load Protection 150 % Line Regulation High Line to Low Line ± 0.5 % Load Regulation Single & Dual (F.L-25%F.L) ± 0.5 % Minimum Load 10% of Full Load Ripple & Noise BW=DC To 20MHz (with 1uF Cap.) 100 mVp-p Transient response setting time current change from 25% to 100% 350 us Parameters Conditions Min Typ Max Units Isolation Resistance 500Vdc 1000 MΩ Switching Frequency 400 KHz Operating Temperature -40 100 ℃ Humidity Non Condensing 95 % Cooling Free air Convection Case material Five-Side Shielded Case Weight 17.5 g Dimensions Appearance size 31.6X20.1X10.0 mm Potting Material Epoxy (UL94V-0 rated) Radiated Emissions EN55022 CLASS A Conducted Emissions EN55022 CLASS A Efficiency 80 % Isolation Voltage For 10 seconds 1500 VDC MTBF MIL-HDBK-217F @25℃ , Ground Benign 900000 Hours Storage Temperature -55 +125 ℃ Case Temperature +95 ℃ Temperature Coefficinet:±0.05%/℃ Single Vin +Vout GND -Vout Cin Cout 100uF/25V 12V & 24V & 48V:Cin 100uF,100V Dual Vin +Vout GND Cin Cout -Vout Cout 24V & 48V:Cin 100uF,100V COM 100uF/25V 100uF/25V C1 C2 12uH 2.2uF/100V 2.2uF/100V +Vin -Vin +Vout -Vout DC/DC Converter Load L |
