Power Entry Module with RFI Power Line Filter for General

or Medical Applications

The L series power entry modules are compact units that

combine a multi-function power entry module and high per-

formance RFI filtering capabilities. They are available with

either a four-voltage selector or a DPST on/off switch. Both

variations can be specified with North American or

European fusing capabilities and are available in either

flange or snap-in mounting.

These filters are UL recognized, CSA certified, and VDE

approved. The L series modules offer a choice of filters for

general or medical applications.

EDL Models

The RFI filter is for general purpose applications where

line-to-line and line-to-ground noise must be controlled.

The filter is designed to meet the very low leakage

requirements of VDE portable equipment. They are

available in three current ratings.

EHL Models

This medical filter provides susceptibility protection

without the leakage current associated with line-to-ground

capacitors. Designed to allow equipment to meet UL544

for patient care and non-patient care equipment, the EHL

filter has a maximum leakage current of 2 µA at 120 VAC

60 Hz. See Appendix C for more information on medical

applications and UL standards.

Note: When using the models with an IEC connector,

remember that the leakage current of the companion line

cord, GA400, is more significant than that of the filter -

which may disqualify this line cord from use in patient care

applications.

118

Catalog 1654001

Dimensions are in inches and

Dimensions are shown for

USA Cust. Svc.: 1-800-468-2023

www.corcom.com

Revised 05-07

millimeters unless otherwise

reference purposes only.

CORCOM Prods: 1-847-680-7400

www.tycoelectronics.com

specified. Values in italics

Specifications subject

Germany:

49-89-6089-0

are metric equivalents.

to change.

L Series

L Series

CORCOM Product Guide

UL Recognized

CSA Certified

VDE Approved

EDL1S/EHL1S

EDL4C/EHL4C

Voltage Selection

To change selected voltage: disconnect the power cord;

open cover using a small blade screwdriver or similar tool;

insert the tool into the voltage selection slot and remove

wheel from unit; select desired voltage; replace wheel into

unit and close cover, making sure the selected voltage

appears in connector window.

Voltage

selection

slot

4-Voltage

selection

wheel

Cover

Fuseholder

Note: All models have North American or dual European fusing capability

and are available in either flange or snap-in mounting.