262

B

B Technical DocumentⅡ

Ⅱ

Connector Mounting Method

1. Soldering Method

This connector and board mounting method uses soldering at the four dip locations marked A at the left and

right sides as well as the two surface mounting locations marked B at the left and right sides for a total of six

locations.

Location A represents board through holes of 1.8mm diameter and 1mm diameter, whereas

location B represents pads of 2.8

× 1.85mm width. (See the board mounting diagram.)

As illustrated in the diagram below, the opening portion of the connector is either inserted into the body of

the set or inserted into a rectangular hole of the set.

2. Soldering and Screw Fastening Method

When there is not sufficient strength with the connector opening portion at the set, the mounting holes C (as

in Figure 1) at the left and right sides of the connector are used after the solder mounting to further fix the

connector with M2 screws.

The connector can be fixed to just the board with this method (as in Figure 2); however, in consideration of

connector twisting, the most effective mounting method is to fix the connector to both the body and the

board with screws as illustrated in Figures 3 and 4.

Connector opening portion

Board

Connector

Board

Body of the set

Nut anchoring

Tapping screw anchoring

（Figure 1）

（Figure 4）

（Figure 3）

（Figure 2）

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.

04/2009