X25041

3

PRINCIPLES OF OPERATION

directly with the synchronous serial peripheral interface

(SPI) of many popular microcontroller families.

The X25041 contains an 8-bit instruction register. It is

accessed via the SI input, with data being clocked in on

the falling SCK.

CS must be LOW during the entire

operation.

Table 1 contains a list of the instructions and their codes.

All instructions, addresses and data are transferred

MSB first.

Data input is sampled on the first falling edge of SCK

after

CS goes LOW. SCK is static, allowing the user to

stop the clock and then resume operations. If the clock

line is shared with other peripheral devices on the SPI

bus, the user can assert the

HOLD input to place the

X25041 into a “PAUSE” condition. After releasing

HOLD,

the X25041 will resume operation from the point when

HOLD was first asserted.

Write Enable Latch

The X25041 contains a “write enable” latch. This latch

must be SET before a write operation will be completed

internally. The WREN instruction will set the latch and

the WRDI instruction will reset the latch. This latch is

automatically reset upon a power-up condition and after

the completion of a byte, page, or status register write

cycle.

Table 1. Instruction Set

Instruction Name

Instruction Format*

Operation

WREN

0000 0110

Set the Write Enable Latch (Enable Write Operations)

WRDI

0000 0100

Reset the Write Enable Latch (Disable Write Operations)

RDSR

0000 0101

Read Status Register

WRSR

0000 0001

Write Status Register

READ

0000 A

Read Data from Memory Array beginning at selected address

WRITE

0000 A

Write Data to Memory Array beginning at Selected Address

(1 to 32 Bytes)

6556 PGM T04

*Instructions are shown MSB in leftmost position. Instructions are transferred MSB first.

7

654

3

2

1

0

X

X

X

X

BP1

BP0

WEL

WIP

6556 PGM T02

Status Register

The RDSR instruction provides access to the status

register. The status register may be read at any time,

even during a write cycle. The status register is format-

ted as follows:

BP0 and BP1 are set by the WRSR instruction. WEL

and WIP are read-only and automatically set by other

operations.

The Write-In-Process (WIP) bit indicates whether the

X25041 is busy with a write operation. When set to a “1”,

a write is in progress, when set to a “0”, no write is in

progress. During a write, all other bits are set to “1”.

The Write Enable Latch (WEL) bit indicates the status of

the “write enable” latch. When set to a “1”, the latch is set,

when set to a “0”, the latch is reset.

The Block Protect (BP0 and BP1) bits are nonvolatile

and allow the user to select one of four levels of protec-

tion. The X25041 is divided into four 1024-bit segments.

One, two, or all four of the segments may be protected.

That is, the user may read the segments but will be

unable to alter (write) data within the selected segments.

The partitioning is controlled as illustrated below.

Status Register Bits

Array Addresses

BP1

BP0

Protected

0

0

None

0

1

$180–$1FF

1

0

$100–$1FF

1

1

$000–$1FF

6556 PGM T03