Electronic Components Datasheet Search |
|
A8L-21-11N3 Datasheet(PDF) 4 Page - Omron Electronics LLC |
|
A8L-21-11N3 Datasheet(HTML) 4 Page - Omron Electronics LLC |
4 / 6 page 4 Miniature Rocker Switch A8L Precautions ■ Correct Use Mounting Turn OFF the power supply before mounting, removing or wiring the Switch, or before performing maintenance inspections. Failure to do so may result in electric shock. Do not use panels other than ones with the designated thickness and dimensions. Remove all burrs from the cutout before installing the Switch. Otherwise, the Switch may malfunction. Do not impose excessive force on the Switch at the time of panel- mounting. There are two small divots in the flange part of the case marking ON and OFF as shown in the following diagram. Use these marks as guides when mounting. Wiring When soldering terminals manually, perform soldering within 3 s using a 60-W soldering iron (temperature at the tip of the soldering iron: 420 °C max.). Do not apply excessive force to the terminals dur- ing soldering. When soldering using a soldering tub, perform soldering within 5 s in a soldering fluid at 270 °C, or within 3 s in a soldering fluid at 350°C. Be sure that the wires are thick enough for the load (current) to be applied. Only A8L- @@-@5@@ models are equipped with (6.3×0.8) mm flat- quick connections for use with #187 fasten receptacles. The terminals of A8L- @@-@1@@ are not in compliance with IEC standards for flat-quick connections. Suitable for use as solder con- nection only. Using Microloads The performance of the Switch may be affected if the Switch is used for switching micro loads. Test the Switch under the actual operating conditions. Operating Environment Do not use the Switch in places with sulfide gas, corrosive gas, sea breeze, oil spray, or direct sunlight. Otherwise, the Switch may mal- function. Do not use the Switch in places that are visibly dusty. Otherwise, the contacts may fail to operate correctly. ■ Cautions To increase the reliability of operation, test the Switch before actual operation. Be sure that there is an enough insulation distance between any Switch terminal and metal part. Handling Do not drop the Switch. Otherwise, the Switch may malfunction. Do not impose excessive force on the Switch. Otherwise, the Switch may deform. The recommended panel material is SPCC. The Switch may fall off if the material is soft and cannot securely hold the Switch. When using a soft material, test the Switch with it before using the Switch in actual operation. ON OFF Do not wire the Switch or touch any terminal of the Switch While power is being supplied. Doing so may result in electric shock. |
Similar Part No. - A8L-21-11N3 |
|
Similar Description - A8L-21-11N3 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |