Transmission/reflection (T/R) calibration (user)

Agilent 85036B/E Type-N calibration kit

1. These specifications are valid for reflection (one-port) and transmission

(enhanced-response) Test Set Cals, and apply under the following conditions:

measurement uses the “Fine” (15 Hz) bandwidth, no averaging, and isolation cal

“on”; Test Set Cals use the “Fine” (15 Hz) bandwidth, 16 averages, and assume an

isolation calibration has been performed; the test set must be used with a

75-Ohm 8712ET, 8712ES, 8714ET, or 8714ES network analyzer with firmware revi-

sion E.06.00 or later; the test set and the analyzer must have had their perfor-

mance verified within the last year; both instruments must have warmed up for at

least 30 minutes after turn-on; measurements are made at an environmental

temperature of 25 °C ± 5 °C and within ± 1 °C of the last valid Test Set Cal.

2. Corrected system performance is changed to typical when the current tempera-

ture has drifted beyond ± 1 °C of the last valid Test Set Cal. Typicals are valid only

when the current temperature is within 25 °C ± 5 °C, and within ± 1 °C of the

most recent SelfCal.

Parameter

3 MHz to 1.3 GHz

3 MHz to 1.3 GHz

Directivity

40

—

Source match

35

—

Load match (reflection calibration)

20

25

Load match (transmission calibration)

15

20

Reflection tracking

±0.1

—

Transmission tracking

±0.1

—

5

System performance