2745 SERIES

NORTH AMERICA

WEBSITE

WORLDWIDE

Labeling

21 CFR 1040.10 Compliance

Because of the small size of these

devices, the output power and laser

emission indicator label shown below is

attached to the individual shipping

container. All labels are illustrated here

to comply with 21 CFR 1040.10 as

applicable under the Radiations Control

for Health and Safety Act of 1968.

User Safety

Safety and Operating Considerations

The laser light emitted from this diode laser is invisible and may be harmful to the human eye. Avoid looking directly into the

fiber when the device is in operation.

CAUTION: THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT INCREASES EYE HAZARD.

Operating the diode laser outside of its maximum ratings may cause device failure or a safety hazard. Power supplies used with

this component cannot exceed maximum peak optical power.

CW diode lasers may be damaged by excessive drive current or switching transients. When using power supplies, the diode

laser should be connected with the main power on and the output voltage at zero. The current should be increased slowly while

monitoring the diode laser output power and the drive current. Careful attention to heatsinking and proper mounting of this

device is required to ensure specified performance over its operating life. To maximize thermal transfer to the heatsink, the

heatsink mounting surface must be flat to within .001”, and the mounting screws must be torqued down to 1.5 in.-lb.

ESD PROTECTION — ESD is the primary cause of unexpected diode laser failure. Take extreme precaution to prevent ESD.

Use wrist straps, grounded work surfaces, and rigorous antistatic techniques when handling diode lasers.

INVISIBLE LASER RADIATION -

AVOID DIRECT EXPOSURE TO BEAM

PEAK POWER 500 mW

WAVELENGTH 630 - 1,550 nm

INVISIBLE

LASER DIODE

Visible/invisible

radiation emitted

from fiber end or

fiber receptacle

AVOID EXPOSURE

CLASS 3B LASER PRODUCT

CAUTION -

Handle with care. Easily damaged

by electrostatic discharge

This product complies with 21 CFR Chapter 1, Subchapter J

DANGER

Serial:

Model:

27-ABC123

27-xxxx-xxx-45

JDS Uniphase (Shenzhen) Ltd

3 Hongmian Road

Futian Free Trade Zone

Shenzhen, China 518038

Made in China

08/18/08 27-ABC123

27-xxxx-xxx-45

Made in China

14-Pin Module Label

Shipping Box Label

Output Power and Laser Emission Indicator Label

Product specifications and descriptions in this document subject to change without notice. © 2009 JDS Uniphase Corporation 30162502 001 0309

2745PUMP.DS.CC.AE

March 2009

PureMode is a registered trademark of Corning Incorporated. Telcordia is a registered trademark of Telcordia Technologies Incorporated.