These devices are intended for wave soldering or manual soldering.

They are not intended to be subject to surface mount processes under any circumstances.

The normal wave soldering process can be used with these devices where the device is subjected to a maximum wave temperature of 260°C for a period of no more than 10 seconds.

Within this time and temperature range, the integrity of the device’s plastic body will not be compromised and internal temperatures within the converter will not exceed 175°C. Care should

be taken to control manual soldering limits identical to that of wave soldering.

THROUGH-HOLE SOLDERING INFORMATION

ABSOLUTE MAXIMUM RATINGS

Output Short-Circuit Duration ........................................................................ Momentary

Internal Power Dissipation...................................................................................750mW

PWR

11XX

C

Device Family

PWR Indicates DC/DC Converter

Model Number

Selected from Table of Electrical Characteristics

RoHS Compliant

ORDERING INFORMATION

APPLICATION NOTE

UNBALANCED LOADS

Unbalanced loads may be used on dual output models with

either side providing up to its rated current. Output voltages,

by design, will track each other in an unbalanced state within

±10% of one another.

OUTPUT NOISE

Output noise can be reduced to 30mVp-p, typically, by adding

a 10μF tantalum capacitor with an equivalent series resistance

(ESR) of less than 150mΩ at 10kHz across each output.

MDC_PWR11xxC.B01 Page 3 of 4

www.murata-ps.com

PWR11xxC

1.5 Watt Unregulated Dual-in-Line DC/DC Converter