Electronic Components Datasheet Search |
|
M95020-W Datasheet(PDF) 10 Page - STMicroelectronics |
|
M95020-W Datasheet(HTML) 10 Page - STMicroelectronics |
10 / 42 page Signal description M95040, M95020, M95010 10/42 Once VCC has passed over the POR threshold, the device is reset and in the following state: ● Standby Power mode ● deselected (at next power-up, a falling edge is required on Chip Select (S) before any instructions can be started) ● not in the Hold condition ● Status Register: – the Write Enable Latch (WEL) is reset to 0 – Write In Progress (WIP) is reset to 0. (The SRWD, BP1 and BP0 bits of the Status Register are non-volatile bits and therefore remain unchanged) Note: Once VCC has passed the power on reset threshold voltage, until VCC reaches the minimum VCC operating voltage, the memory must not be selected/accessed. 2.8.4 Power-down At power-down (continuous decrease in VCC below the minimum VCC operating voltage), the device must be: ● deselected (Chip Select S should be allowed to follow the voltage applied on VCC) ● in Standby Power mode (that should not be any internal write cycle in progress) |
Similar Part No. - M95020-W |
|
Similar Description - M95020-W |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |