Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833

603-778-2300 www.wallindustries.com Fax 603-778-9797

PSPRL9802 Series

Active PFC

200 Watt Single Output

AC/DC Switching Power Supply

FEATURES

● 2 Year Warranty

● Optional Top Cover

● 90 ~ 264VAC Universal AC Input

● Approved to UL CUL TUV CE and CB

● Power Factor Corrected to EN61000-3-2 Class D

● Compact 1U Size & Power Density: 5.2 Watts/cu in.

● Providing Peak Power 600W within 500uS Duty Duration

● Convection-Cooled and with Forced Air Cooling Rating Options

● Protections: Short Circuit/ Over Load/ Over Voltage/ Over Temp

All specifications are based on 25

We reserve the right to change specifications based on technological advances.

INPUT SPECIFICATIONS

Input Voltage

90 – 264VAC Full Range

Input Frequency

47 to 63Hz

Input Current

4A at 100VAC full load

Inrush Current

35A max @ 110VAC with full load and cold start.

Leakage Current

1.5mA max @ 240VAC

Remote ON/OFF

Designated as REMO on the CN3, requires a low signal to inhibit output. Hiccup mode.

OUTPUT SPECIFICATIONS

Output Voltage

See Table

Output Power Range

200 Watts max.

Output Adjustability

Output user adjustable ±5% minimum.

Total Regulation

±1%

Output Current

See Table

Ripple & Noise (peak to peak)

See Table

Transient Response

Output voltage returns to within 1% in less than 500µs for a 50% dynamic load, peak does not excess 5%.

Hold-Up Time

20ms min. at 80% of full load.

Overshoot

Turn-on/off not exceed 5% over nominal voltage.

Turn On Delay

1 second maximum at 120VAC.

Remote Sense

Designated as RS+ and RS- on the CN3

PROTECTION

Over Voltage Protection

Latching down will occur when output voltage exceeds 130% and recycle AC input to reset.

Short Circuit Protection

Trip without damage and auto-recovery.

Over-Temperature Protection

Protected in the event of excessive operating ambient 85°C and automatic recovery.

Over-Power Protection

Hiccup mode 110-140%; auto-recovery.

Input Circuit Protection

A protected 250V/5A fuse inserted.

GENERAL SPECIFICATIONS

Efficiency

70% for 3.3V, 75% for 5V, 80% for 12V, and 83% minimum for other outputs @ 230VAC and full load.

Withstand Voltage

1500 VAC input line to chassis (10mA DC cut off current, isolating 3000VAC primary to secondary

windings. Primary to core 1500VAC. All for 3 seconds.

Burn In

45 ±5°C for one hour @ 230VAC with full load.

PFC

Active power factor correction meets EN61000-3-2 class D.

Power Good

Designated as PG on the CN3 will go high 100-500ms after regulation and goes low 1ms before loss of

regulation.

Power Supply On

Green LED designated as LED 1 on the PCB.

Grounding Test

Apply 25A from ground pin of the three-prong plug to the far most earth. Max allowable resistance 0.1 ohm.