DQ

Name

Logic Level

Definition

Note

7

Data

Polling

’1’

Erase Complete or erase

block in Erase Suspend

Indicates the P/E.C. status, check during

Program or Erase, and on completion

before checking bits DQ5 for Program or

Erase Success.

’0’

Erase On-going

DQ

Program Complete or data

of non erase block during

Erase Suspend

DQ

Program On-going

6

Toggle Bit

’-1-0-1-0-1-0-1-’

Erase or Program On-going

Successive reads output complementary

data on DQ6 while Programming or Erase

operations are on-going. DQ6 remains at

constant level when P/E.C. operations are

completed or Erase Suspend is

acknowledged.

DQ

Program Complete

’-1-1-1-1-1-1-1-’

Erase Complete or Erase

Suspend on currently

addressed block

5

Error Bit

’1’

Program or Erase Error

This bit is set to ’1’ in the case of

Programming or Erase failure.

’0’

Program or Erase On-going

4

Reserved

3

Erase

Time Bit

’1’

Erase Timeout Period Expired

P/E.C. Erase operation has started. Only

possible command entry is Erase Suspend

(ES).

’0’

Erase Timeout Period

On-going

An additional block to be erased in parallel

can be entered to the P/E.C.

2

Toggle Bit

’-1-0-1-0-1-0-1-’

Chip Erase, Erase or Erase

Suspend on the currently

addressed block.

Erase Error due to the

currently addressed block

(when DQ5 = ’1’).

Indicates the erase status and allows to

identify the erased block

1

Program on-going, Erase

on-going on another block or

Erase Complete

DQ

Erase Suspend read on

non Erase Suspend block

1

Reserved

0

Reserved

Notes: Logic level ’1’ is High, ’0’ is Low. -0-1-0-0-0-1-1-1-0- represent bit value in successive Read operations.

Table 9. Status Register Bits

Toggle Bit (DQ6). When Programming or Erasing

operations are in progress, successive attempts to

read DQ6 will output complementarydata. DQ6 will

toggle following toggling of either G, or E when G

is low. The operation is completed when two suc-

cessive reads yield the same output data. The next

read will output the bit last programmed or a ’1’ after

erasing. The toggle bit DQ6 is valid only during

P/E.C. operations, that is after the fourth W pulse

for programming or after the sixth W pulse for

Erase. If the blocks selected for erasure are pro-

tected, DQ6 will toggle for about 100

µs and then

return back to Read. DQ6 will be set to ’1’ if a Read

operationis attemptedon an Erase Suspendblock.

When erase is suspended DQ6 will toggle during

programming operations in a block different to the

block in Erase Suspend. Either E or G toggling will

cause DQ6 to toggle. See Figure 12 for Toggle Bit

flowchart and Figure 13 for Toggle Bit waveforms.

10/33

M29F200T, M29F200B