EVERLIGHT ELECTRONICS CO.,LTD.

Everlight Electronics Co., Ltd.

http:\\www.everlight.com

Rev

1

Page: 10 of 12

Device No

： DMO-538-400

Prepared date

：11-24-2006

Prepared by

：Cindy Lin

IRM-H538/TR2

Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3

seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more

intervals, and do soldering of each terminal. Be careful because the damage of the product is often

started at the time of the hand solder.

Repairing

Repair should not be done after the Devices have been soldered. When repairing is

unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed

beforehand whether the characteristics of the Devices will or will not be damaged by repairing.