ELSEMA
1,2,3,4,8 -Channel 433MHz,25mWatt Transmitter.
Transmitter Modes
Off Delay 2 – 62 seconds
Transmitter will transmit a 1.5 second transmission burst and then stop for the "off
delay" time selected. The "off delay" time is user selectable between 2 to 62 seconds
by adjusting the trimpot of the transmitter board. If another channel is activated
during the "off delay" period the new channel will be transmitted immediately. When
the "off delay" time lapses, transmitter will transmit another burst. The transmitter
will cycle (transmission and off delay) indefinitely, if at least one channel is activated
and the supply is connected.
Off Delay 10sec – 10 minutes
Same as mode 1 except the "off delay" is user selectable between 10sec to 10
minutes.
Continuous Transmission*
Transmitter will transmit continuously, if at least one channel is activated and supply
is connected. A transmission limit of five minutes is used to comply with local radio
regulations.
To activate a receiver longer than 5 minutes, use a delay off feature in the receiver
(GLR43301) and transmitter. The delay off feature in the receiver needs to be set
more than the transmitter. This ensures that the transmitter keeps resetting the off
delay in the receiver. Refer to Application Note
1.5 – 10 seconds one burst transmission
Transmitter will transmit one burst and then go to standby or sleep mode. Adjusting
the trimpot will vary the burst length. When another channel is activated and supply
is connected, transmitter will emit one new burst.
Sleep mode (20 uA) is activated when all 8-channels are OFF, this applies to all four modes.
(Grey illustrates the position of the DIP switches)
* Refer to the website for further details. Continuous Transmission