M28C17-150K1T datasheet(4/17 Pages) STMICROELECTRONICS

Part #	M28C17-150K1T

Description	16K 2K x 8 PARALLEL EEPROM with SOFTWARE DATA PROTECTION

Download	17 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

4 / 17 page

AI01488

ADDRESS

LATCH

A6-A10

(Page Address)

CONTROL LOGIC

64K ARRAY

ADDRESS

LATCH

A0-A5

Y DECODE

VPP GEN

RESET

SENSE AND DATA LATCH

I/O BUFFERS

RB

E

G

W

PAGE LOAD

TIMER STATUS

TOGGLE BIT

DATA POLLING

DQ0-DQ7

Figure 3. Block Diagram

Microcontroller Control Interface

The M28C17 provides two write operation status

bits and one status pin that can be used to minimize

the system write cycle. These signals are available

on the I/O port bits DQ7 or DQ6 of the memory

during programming cycle only, or as the RB signal

on a separate pin.

DQ7 DQ6 DQ5 DQ4 DQ3 DQ2 DQ1 DQ0

DP

TB

PLTS Hi-Z

Hi-Z

Figure 4. Status Bit Assignment

DP = Data Polling

TB = Toggle Bit

PLTS = Page Load Timer Status

Data Polling bit (DQ7). During the internal write

cycle, any attempt to read the last byte written will

produce on DQ7 the complementary value of the

previously latched bit. Once the write cycle is fin-

ished the true logic value appears on DQ7 in the

read cycle.

Toggle bit (DQ6). The M28C17 offers another way

for determining when the internal write cycle is

completed. During the internal Erase/Write cycle,

DQ6 will toggle from "0" to "1" and "1" to "0" (the

first read value is "0") on subsequent attempts to

read the memory. When the internal cycle is com-

pleted the toggling will stop and the device will be

accessible for a new Read or Write operation.

Page Load Timer Status bit (DQ5). In the Page

Write mode data may be latched by E or W. Up to

64 bytes may be input. The Data output (DQ5)

indicates the status of the internal Page Load

Timer. DQ5 may be read by asserting Output En-

able Low (tPLTS). DQ5 Low indicates the timer is

running, High indicates time-out after which the

write cycle will start and no new data may be input.

Ready/Busy pin. The RB pin provides a signal at

its open drain output which is low during the

erase/write cycle, but which is released at the

completion of the programming cycle.

4/17

M28C17

Similar Part No. - M28C17-150K1T

Manufacturer	Part #	Datasheet	Description
STMicroelectronics	M28C17-150K1TR	131Kb / 17P	16 Kbit 2K x 8 Parallel EEPROM With Software Data Protection

More results

Similar Description - M28C17-150K1T

Manufacturer	Part #	Datasheet	Description
STMicroelectronics	M28C16	129Kb / 18P	16K 2K x 8 PARALLEL EEPROM with SOFTWARE DATA PROTECTION
	M28LV16	123Kb / 17P	16K (2K x 8) LOW VOLTAGE PARALLEL EEPROM with SOFTWARE DATA PROTECTION
	M28C16B	131Kb / 17P	16 Kbit 2K x 8 Parallel EEPROM With Software Data Protection
	M28C64	153Kb / 24P	64 Kbit 8K x 8 Parallel EEPROM With Software Data Protection
	M28010	150Kb / 23P	1 Mbit 128K x 8 Parallel EEPROM With Software Data Protection
Microchip Technology	28C16A	64Kb / 8P	16K (2K x 8) CMOS EEPROM 1996
Microchip Technology	28C16A	125Kb / 10P	16K (2K x 8) CMOS EEPROM 2004
STMicroelectronics	M28LV64	127Kb / 18P	64K 8K x 8 LOW VOLTAGE PARALLEL EEPROM with SOFTWARE DATA PROTECTION
Microchip Technology	28C17A	67Kb / 8P	16K (2K x 8) CMOS EEPROM 1996
Renesas Technology Corp	X4163	880Kb / 22P	16K, 2K x 8 Bit CPU Supervisor with 16K EEPROM November 26, 2007

More results

M28C17-150K1T Datasheet(PDF) 4 Page - STMicroelectronics

M28C17-150K1T Datasheet(HTML) 4 Page - STMicroelectronics

Similar Part No. - M28C17-150K1T

Similar Description - M28C17-150K1T

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Datasheet Download

Link URL