JNPS-0846
9
6-3 ELECTRICAL SPECIFICATIONS
TEST
DESCRIPTION
REQUIREMENT
TEST CONDITION
RELATED
STANDARD
DIELECTRIC
WITHSTANDING
VOLTAGE
No appearance of arcing
and break down.
Leak current: 1mA Max.
Impressed voltage is AC 1000V rms.
between adjacent two contacts for one
minute.
――――
INSULATION
RESIDENSE
1000M
Ω Min.
Impressed voltage is DC 500V between
adjacent two contacts for one minute.
――――
CONTACT
RESISTANCE
- Initial /
25 m
Ω Max.
- Change of contact
resistance after
environmental tests /
20 m
Ω Max.
Contact resistance is measured
at Short Circuit.
Current: 1.5mA
Open Circuit Voltage: 20mV
by 4 terminal method.
* Measurement values include
the resistance of contact pins
as conductive material.
* Refer to Table 1 regarding the conditions
of each environmental test.
See Table 1.
Table 1: ENVIROMENTAL TEST
ITEM
TEST CONDITION
RELATED STANDARD
MOISTURE
-10
∼ 65°C, Relative Humidity 95% / 10 cycles
MIL-STD-202F106D
SALT SPRAY
NaCl 5% solution, 35
°C / 48 hours
MIL-STD-202F101D
THERMAL SHOCK
-55
°C→25°C→85°C→25°C / 5 cycles
MIL-STD-202F107G
HUMIDITY
(STEADY STATE)
40
°C, Relative Humidity 95% / 96 hours
MIL-STD-202F103B
THERMAL LIFE
Steady Current: Current Rating
× 110%, 85°C / 1000 hours
――――
H2S GAS
3
± 1 ppm, 40°C, Relative Humidity 70 ∼ 80% / 96 hours
JEIDA-38-1984
7. PLATING SPEC INDICATION ON CONNECTOR
The first letter, in stamped 3 letters on the connector body for lot numbering, identified the following
plating specs.
N XX or n XX : PR plating
C XX or c XX : SC plating
S XX or s XX : S plating
* XX : two alphabet letters
8. PACKAGE & IDENTIFICATION
These products are packed with plastic tray and carton box for transit.
Carton box are identified by part number, quantity, maker name and lot number.