TA78033, 04, 05, 07, 08, 09AF

2006-11-06

6

Electrical Characteristics for All Products

Generally, the characteristics of power supply ICs vary with temperature.

The ratings at Tj = 25℃assume that a temperature increase has no effect on IC characteristics as ascertained by

pulse tests.

Standard Application Circuit

• Place

terminal and GND. Although capacitor

output oscillation or load change, it might cause output oscillation in a cold environment due to increased

capacitor ESR. It is therefore recommended to use a capacitor with small variations temperature sensitivity.

The IC may oscillate due to external conditions (output current, temperature, or the type of the capacitor

used). The type of capacitor required must be determined by the actual application circuit in which the IC is

used.

The notice in case of application

• If the input terminal shorts to GND in a state of normal operation, the output terminal voltage becomes

higher than the input voltage (GND potential), and the electric charge of a chemical capacitor connected to

the output terminal flows into the input side, which may cause the destruction of circuit.

In these cases, take such steps as a zener diode and a general silicon diode are connected to the circuit, as

shown in the above figure

• There is a possibility that internal parasitic devices may be generated when momentary transients cause a

terminal’s potential to fall below that of the GND terminal. In such case, that the device could be destroyed.

The voltage of each terminal and any state must therefore never fall below the GND potential.

1

2

TA78xxxAF

3

0.33

μF

0.1

μF

IN

OUT

GND