LG

Specifications

Higher Capacitance, Low ESR, High ripple current.

Load life of 2000 hours at 105

°C.

Radial lead type :

Lead free flow soldering condition correspondence

Adapted to the RoHS directive (2002/95/EC).

series

Item

Performance Characteristics

Category Temperature Range

Rated Voltage Range

Rated Capacitance Range

Capacitance Tolerance

tan

δ

ESR ( 1)

Leakage Current ( 2)

Characteristics of Temperature

Impedance Ratio

Endurance

Damp Heat

Resistance to

Soldering Heat

Marking

–55 to +105

°C

2.5 to 16V

330 to 3900

µF

± 20% at 120Hz, 20°C

Not more than value of Standard ratings

at 120Hz, 20

°C

Not more than value of Standard ratings

at 100kHz, 20

°C

Not more than value of Standard ratings.

After 2 minute's application of rated voltage.

20

°C

Z +105

°C / Z+20°C 1.25

(100kHz)

Z-55

°C / Z + 20°C 1.25

After 2000 hours' application of rated voltage

at 105

°C, capacitors meet the specified value

for life characteristics listed at right.

After 1000 hours' application of rated voltage

at 60

°C 90%RH, capacitors meet the specified

value for life characteristics listed at right.

To comply with recommended conditions for

reflow soldering. Pre-heating shall be done

at 150 to 200

°C and for 60 to 180 sec.

Peak temp. is 265

°C, within 10 sec.

Measurement for solder temperature profile

shall be made at a point on the terminal

nearest where the terminals protrude through

the soldering side of PC board.

Navy blue print on the case top.

CONDUCTIVE POLYMER

ALUMINUM SOLID ELECTROLYTIC CAPACITORS

Capacitance change

tan

δ

ESR ( 1)

Leakage current ( 2)

Within

± 20% of initial value ( 3)

150% or less of the initial specified value

150% or less of the initial specified value

Initial specified value or less

Capacitance change

tan

δ

ESR ( 1)

Leakage current ( 2)

Within

± 20% of initial value ( 3)

150% or less of the initial specified value

150% or less of the initial specified value

Initial specified value or less

Capacitance change

tan

δ

ESR ( 1)

Leakage current ( 2)

Within

± 10% of initial value ( 3)

130% or less of the initial specified value

130% or less of the initial specified value

Initial specified value or less

( 1) ESR measurements should be made at a point on the terminal nearest the end seal of the capacitor.

( 2) Conditioning : If there is doubt about the measured result, measurement should be made again after the rated voltage is applied for 120 minutes

at the temperature of 105

°C.

( 3) Initial value : The value before test of examination of resistance to soldering.

Radial Lead Type, Higher Capacitance

LF

LG

Higher

Capacitance