This Data Sheet may be revised by subsequent versions

©2004 Eon Silicon Solution, Inc., www.essi.com.tw

or modifications due to changes in technical specifications.

1

EN25P05

Rev. B, Issue Date: 2006/12/27

FEATURES

• Single power supply operation

- Full voltage range: 2.7-3.6 volt

• 512 Kbit Serial Flash

- 512 K-bit/64 K-byte/256 pages

- 256 bytes per programmable page

• High performance

- 75MHz clock rate

• Low power consumption

- 5 mA typical active current

- 1

μA typical power down current

• Uniform Sector Architecture:

- Two 32-Kbyte sectors

• Software and Hardware Write Protection:

- Write Protect all or portion of memory via

software

- Enable/Disable protection with WP# pin

• High performance program/erase speed

- Byte program time: 8µs typical

- Page program time: 1.5ms typical

- Sector erase time: 500ms typical

- Chip erase time: 1 Seconds typical

• Minimum 100K endurance cycle

• Package Options

- 8 pins SOP 150mil body width

- 8 contact VDFN

- All Pb-free packages are RoHS compliant

• Commercial and industrial temperature

Range

GENERAL DESCRIPTION

The EN25P05 is a 512 K-bit (64K-byte) Serial Flash memory, with advanced write protection

mechanisms, accessed by a high speed SPI-compatible bus. The memory can be programmed 1 to

256 bytes at a time, using the Page Program instruction.

The EN25P05 is designed to allow either single Sector at a time or full chip erase operation. The

EN25P05 can be configured to protect part of the memory as the software protected mode. The

device can sustain a minimum of 100K program/erase cycles on each sector.

EN25P05

512 Kbit Uniform Sector, Serial Flash Memory