2

Rev P 11/20/06

© 2006 Sipex Corporation

ELECTRICAL SPECIFICATIONS

These are stress ratings only and functional operation of the device at

these ratings or any other above those indicated in the operation sections

of the specifications below is not implied. Exposure to absolute maximum

rating conditions for extended periods of time may affect reliability.

ABSOLUTE MAXIMUM RATINGS

Supply Voltage (Vcc).................................................-0.3V to + 6.0V

V+ (Note 1)................................................................-0.3V to + 7.0V

V- (Note 1).................................................................+0.3V to - 7.0V

|V+| + |V-| .................................................................................+13V

Input voltage at TTL input pins ............................-0.3V to Vcc+0.3V

RxIN......................................................................................... ±18V

Driver output (from Ground).................................................. ±13.2V

RxOUT, STATUS..................................................-0.3V to Vcc+0.3V

Short Circuit Duration, TxOUT to GND,. Continuous

(One output at a time maximum)

Storage Temperature...............................................-65°C to +150°C

Operating Temperature SP322XECX...........................0°C to +70°C

Operating Temperature SP322XEEX........................-40°C to +85°C

Lead Temperature (soldering, 10s)....................................... +300°C

Maximum junction temperature.....................................................150°C

Thermal Derating, Junction to Ambient

SSOP20..............................................................................

TSSOP20.......................................................................

SSOP16..............................................................................

TSSOP16.......................................................................

Note 1: V+ and V- can have maximum magnitudes of 7V, but their

absolute difference cannot exceed 13V.

C1–C4 = 0.1µF tested at 3.3V ±10%. C1=0.047µF C2–C4 = 0.33µF tested at 5V ±10%.

Parameters

Symb

Test Conditions

Min.

Typ.

Max.

Unit

DC Characteristics

Supply Current, Auto On-Line

® Plus

Receivers idle, TxIN = Vcc or GND,

ONLINE = GND, SHUTDOWN = Vcc

Note 2

1

10

µA

Supply Current, Shutdown

SHUTDOWN = GND

1

10

µA

Supply Current, Active

ONLINE = SHUTDOWN = Vcc, No Load

1.5

2.0

mA

Supply Current, Active

No Load

0.7

1.0

mA

Driver Input and Logic Input Pins

Logic Input

Voltage

High

Vcc = 3.3V

2

V

Vcc = 5.0V

2.4

Low

0.8

Logic Threshold

1.5

Logic Input Leakage Current

0.05

±1.0

µA

Logic Input Hysteresis

100

mV

Receiver Outputs and STATUS Output

Receiver Output Voltage Low

0.4

V

Receiver Output Voltage High

Vcc

- 0.6

V

Note 2: Characterized, not 100% tested.