2

PS8723C

05/08/06

PI3CH800

Low Voltage, 5Ω, 8-Channel

Storage Temperature ................................................ –65°C to +150°C

Ambient Temperature with Power Applied ............... –40°C to +85°C

Supply Voltage to Ground Potential ........................... –0.5V to +4.6V

DC Input Voltage ........................................................ –0.5V to +6.0V

DC Output Current................................................................... 120mA

Power Dissipation ....................................................................... 0.5W

Note:

Stresses greater than those listed under MAXIMUM

RATINGS may cause permanent damage to the device. This is a

stress rating only and functional operation of the device at these

or any other conditions above those indicated in the operational

sections of this specification is not implied. Exposure to absolute

maximum rating conditions for extended periods may affect re-

liability.

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

Parameters

Description

Min.

Max.

Units

Input HIGH Voltage

Guaranteed Logic HIGH Level

2

V

Input LOW Voltage

Guaranteed Logic LOW Level

–0.5

0.8

Clamp Diode Voltage

–1.3

–1.8

Input HIGH Current

±1

µA

Input LOW Current

±1

High-Impedence Current

±1

or –64mA

4

6

Ω

5

8

Parameters

Description

Max.

Units

Input HIGH Voltage

Guaranteed Logic HIGH Level

1.8

V

Inout LOW Voltage

Guaranteed Logic LOW Level

–0.3

0.8

Clamp Diode Voltage

–0.7

–1.8

Input HIGH Current

±1

µA

Input LOW Current

±1

High Impedance Current

±1

4

8

Ω

7

14

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined

by the lower of the voltages on the two (A,B) pins.

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined

by the lower of the voltages on the two (A,B) pins.

06-0235