LOW POWER QUAD OPERATIONAL AMPLIFIERS

AZ324

Data Sheet

4

Aug. 2006 Rev. 1. 3

BCD Semiconductor Manufacturing Limited

Parameter

Symbol

Value

Unit

Power Supply Voltage

20

V

Differential Input Voltage

20

V

Input Voltage

-0.3 to 20

V

50

mA

Output Short Circuit to Ground (One

(Note 3)

Continuous

DIP

1130

mW

SOIC

800

Operating Junction Temperature

150

Storage Temperature Range

-65 to 150

Lead Temperature (Soldering, 10 Seconds)

260

Note 1: Stresses greater than those listed under "Absolute Maximum Ratings" may cause permanent damage to the

device. These are stress ratings only, and functional operation of the device under these conditions is not implied.

Exposure to "Absolute Maximum Ratings" for extended periods may affect device reliability.

Note 2: This input current will only exist when the voltage at any of the input leads is driven negative. It is due to

the collector-base junction of the input PNP transistors becoming forward biased and thereby acting as input diode

clamps. In addition to this diode action, there is also lateral NPN parasitic transistor action on the IC chip. This

large overdrive) for the time duration that an input is driven negative. This is not destructive and normal output

states will re-establish when the input voltage, which was negative, again returns to a value greater than -0.3V (at

ering short circuits to ground, the maximum output current is approximately 40mA independent of the magnitude

ratings and cause eventual destruction. Destructive dissipation can result from simultaneous shorts on all amplifi-

ers.

Absolute Maximum Ratings (Note 1)

Recommended Operating Conditions

Parameter

Symbol

Min

Max

Unit

Supply Voltage

318

V

Ambient Operating Temperature Range

-40

85