9

AT25080/160/320/640

0675M–SEEPR–9/03

WRITE STATUS REGISTER (WRSR): The WRSR instruction allows the user to select one of

four levels of protection. The AT25080/160/320/640 is divided into four array segments. One

quarter (1/4), one half (1/2), or all of the memory segments can be protected. Any of the data

within any selected segment will therefore be READ only. The block write protection levels and

corresponding status register control bits are shown in Table 4.

The three bits, BP0, BP1, and WPEN are nonvolatile cells that have the same properties and

The WRSR instruction also allows the user to enable or disable the write protect (WP) pin

through the use of the Write Protect Enable (WPEN) bit. Hardware write protection is enabled

when the WP pin is low and the WPEN bit is “1”. Hardware write protection is disabled when

either the WP pin is high or the WPEN bit is “0”. When the device is hardware write protected,

writes to the Status Register, including the Block Protect bits and the WPEN bit, and the block-

protected sections in the memory array are disabled. Writes are only allowed to sections of the

memory which are not block-protected.

NOTE: When the WPEN bit is hardware write protected, it cannot be changed back to “0”, as

long as the WP pin is held low.

Table 4. Block Write Protect Bits

Level

Status

Register Bits

Array Addresses Protected

BP1

BP0

AT25080

AT25160

AT25320

AT25640

0

0

0

None

None

None

None

1(1/4)

0

1

0300

-03FF

0600

-07FF

0C00

-0FFF

1800

-1FFF

2(1/2)

1

0

0200

-03FF

0400

-07FF

0800

-0FFF

1000

-1FFF

3(All)

1

1

0000

-03FF

0000

-07FF

0000

-0FFF

0000

-1FFF

Table 5. WPEN Operation

WPEN

WP

WEN

Protected

Blocks

Unprotected

Blocks

Status

Register

0

X

0

Protected

Protected

Protected

0

X

1

Protected

Writable

Writable

1

Low

0

Protected

Protected

Protected

1

Low

1

Protected

Writable

Protected

X

High

0

Protected

Protected

Protected

X

High

1

Protected

Writable

Writable