Electronic Components Datasheet Search
Selected language     English  ▼
Part Name
         Description


NCP1203D60R2 Datasheet(PDF) 7 Page - ON Semiconductor

Part No. NCP1203D60R2
Description  PWM Current−Mode Controller for Universal Off−Line Supplies Featuring Standby and Short Circuit Protection
Download  15 Pages
Scroll/Zoom Zoom In 100% Zoom Out
Maker  ONSEMI [ON Semiconductor]
Homepage  http://www.onsemi.com
Logo 

 7 page
background image
NCP1203
http://onsemi.com
7
APPLICATION INFORMATION
Introduction
The NCP1203 implements a standard current mode
architecture where the switch−off time is dictated by the
peak current setpoint. This component represents the ideal
candidate where low part−count is the key parameter,
particularly in low−cost AC−DC adapters, auxiliary
supplies etc. Due to its high−performance SMARTMOS
High−Voltage technology, the NCP1203 incorporates all the
necessary components normally needed in UC384X based
supplies: timing components, feedback devices, low−pass
filter and startup device. This later point emphasizes the fact
that ON Semiconductor’s NCP1203 does not need an
external startup resistance but supplies the startup current
directly from the high−voltage rail. On the other hand, more
and more applications are requiring low no−load standby
power, e.g. for AC−DC adapters, VCRs etc. UC384X series
have a lot of difficulty to reduce the switching losses at low
power levels. NCP1203 elegantly solves this problem by
skipping unwanted switching cycles at a user−adjustable
power level. By ensuring that skip cycles take place at low
peak current, the device ensures quiet, noise free operation.
Finally, an auto−recovery output short−circuit protection
(OCP) prevents from any lethal thermal runaway in
overload conditions.
Startup Sequence
When the power supply is first powered from the mains
outlet, the internal current source (typically 6.0 mA) is
biased and charges up the VCC capacitor. When the voltage
on this VCC capacitor reaches the VCC(on) level (typically
12.8 V), the current source turns off and no longer wastes
any power. At this time, the VCC capacitor only supplies the
controller and the auxiliary supply is supposed to take over
before VCC collapses below VCC(min). Figure 13 shows the
internal arrangement of this structure:
Figure 13. The Current Source Brings VCC Above 12.8 V and then Turns Off
+
8
6
4
6 mA or 0
CVCC
Aux
HV
12.8 V/4.9 V
Once the power supply has started, the VCC shall be
constrained below 16 V, which is the maximum rating on
pin 6. Figure 14 portrays a typical startup sequence with a
VCC regulated at 12.5 V:
Figure 14. A Typical Startup Sequence for
the NCP1203
t, TIME (sec)
3.00 M
8.00 M
13.0 M
18.0 M
23.0 M
13.5
12.5
11.5
10.5
9.5
REGULATION
12.8 V




Html Pages

1  2  3  4  5  6  7  8  9  10  11  12  13  14  15 


Datasheet Download



Related Electronics Part Number

Part NumberComponents DescriptionHtml ViewManufacturer
NCP1201_06PWM Current−Mode Controller for Universal Off−Line Supplies Featuring Low Standby Power with Fault Protection Modes 1 2 3 4 5 MoreON Semiconductor
NCP1200_06PWM Current−Mode Controller for Low−Power Universal Off−Line Supplies 1 2 3 4 5 MoreON Semiconductor
ISL6322Four-Phase Buck PWM Controller with Integrated MOSFET Drivers and I2C Interface for Intel VR10 VR11 and AMD Applications 1 2 3 4 5 MoreIntersil Corporation
NCP1207A_06PWM Current−Mode Controller for Free Running Quasi−Resonant Operation 1 2 3 4 5 MoreON Semiconductor
NCP1337PWM Current−Mode Controller for Free Running Quasi−Resonant Operation 1 2 3 4 5 MoreON Semiconductor
NCP1030_06Low Power PWM Controller with On−Chip Power Switch and Startup Circuits for 48V Telecom Systems 1 2 3 4 5 MoreON Semiconductor
ISL6327Enhanced 6-Phase PWM Controller with 8-Bit VID Code and Differential Inductor DCR or Resistor Current Sensing 1 2 3 4 5 MoreIntersil Corporation
NCP4326Secondary Controller for Multi−Output Quasi−Resonant Switchmode Power Supplies 1 2 3 4 5 MoreON Semiconductor
MC44604_05High Safety Pulsed Mode Standby GreenLine TM PWM Controller 1 2 3 4 5 MoreON Semiconductor
NCP348Positive Overvoltage Protection Controller with Internal Low R_ON NMOS FET and Status FLAG 1 2 3 4 5 MoreON Semiconductor

Link URL

Does ALLDATASHEET help your business so far?  [ DONATE ]  

About Alldatasheet   |   Advertisement   |   Datasheet Upload   |   Contact us   |   Privacy Policy   |   Bookmark   |   Link Exchange   |   Manufacturer List
All Rights Reserved© Alldatasheet.com 2003 - 2017    


Mirror Sites
English : Alldatasheet.com  , Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp  |   Russian : Alldatasheetru.com
Korean : Alldatasheet.co.kr   |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com  |   Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl