Electronic Components Datasheet Search |
|
MAX5924AEUB Datasheet(PDF) 4 Page - Maxim Integrated Products |
|
MAX5924AEUB Datasheet(HTML) 4 Page - Maxim Integrated Products |
4 / 20 page 1V to 13.2V, n-Channel Hot-Swap Controllers Require No Sense Resistor 4 _______________________________________________________________________________________ Typical Operating Characteristics (VCC = 5V, CL = 100µF, CSLEW = 330nF, CGATE = 10nF, RL = 500Ω, Figure 1, TA = +25°C, unless otherwise noted.) MAX5926 SUPPLY CURRENT vs. SUPPLY VOLTAGE VCC (V) 12 10 8 6 4 0.4 0.8 1.2 1.6 2.0 0 214 VCC = VS ENABLED DISABLED MAX5926 SUPPLY CURRENT vs. TEMPERATURE TEMPERATURE (°C) 60 35 10 -15 0.4 0.8 1.2 1.6 2.0 2.4 0 -40 85 VCC = VS VCC = 13.2V VCC = 5.0V VCC = 3.0V VCC = 2.25V GATE-DRIVE VOLTAGE vs. SUPPLY VOLTAGE VCC (V) 12 10 8 6 4 3 4 5 6 7 2 214 VS = 1V VS = 3V VS = 5V VS = VCC GATE-DRIVE VOLTAGE vs. TEMPERATURE TEMPERATURE (°C) 60 35 10 -15 3.5 4.0 4.5 5.0 5.5 6.0 3.0 -40 85 VCC = VS VCC = 5.0V VCC = 3.0V VCC = 13.2V CIRCUIT-BREAKER CURRENT vs. HOT-SWAP VOLTAGE VS (V) 12 10 8 6 4 2 40 44 48 52 56 36 014 VCC = 13.2V TC = 3300ppm/°C TC = 0ppm/°C CIRCUIT-BREAKER CURRENT vs. SUPPLY VOLTAGE (TC = 3300ppm/°C) VCC (V) 12 10 8 6 4 49 51 53 55 47 214 VCC = VS ELECTRICAL CHARACTERISTICS (continued) (VCC, EN (MAX5924/MAX5925), EN1 (MAX5926) = +2.25V to +13.2V; EN2 (MAX5926) = 0V; VS (see Figure 1) = +1.05V to VCC; TA = -40°C to +85°C, unless otherwise noted. Typical values are at VCC = 5V, RL = 500Ω from OUT to GND, CL = 100µF, SLEW = open, TA = +25°C, unless otherwise noted.) (Note 1) Note 1: All devices are 100% tested at TA = +25°C and +85°C. All temperature limits at -40°C are guaranteed by design. Note 2: VCC drops 30% below the undervoltage lockout voltage during tDG are ignored. Note 3: RLP is the resistance measured between VCC and SC_DET during the load-probing phase, tLP. Note 4: Guaranteed by design. Note 5: The circuit-breaker programming current increases linearly from VCC = 2.25V to 5V. See the Circuit-Breaker Current vs. Supply Voltage graph in the Typical Operating Characteristics. Note 6: See the Startup Mode section for more information. Note 7: VGATE is clamped to 17V (typ) above ground. Note 8: dv/dt = 330 x 10-9/CSLEW (V/ms), nMOS device used for measurement was IRF9530N. Slew rate is measured at the load. |
Similar Part No. - MAX5924AEUB |
|
Similar Description - MAX5924AEUB |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |