ZXTDC3M832

ISSUE 1 - JUNE 2002

2

PARAMETER

SYMBOL

NPN

PNP

UNIT

Collector-Base Voltage

100

-50

V

Collector-Emitter Voltage

50

-40

V

Emitter-Base Voltage

7.5

-7.5

V

Peak Pulse Current

6-4

A

Continuous Collector Current (a)(f)

4-3

A

Base Current

1000

mA

Power Dissipation at TA=25°C (a)(f)

Linear Derating Factor

1.5

12

W

mW/°C

Power Dissipation at TA=25°C (b)(f)

Linear Derating Factor

2.45

19.6

W

mW/°C

Power Dissipation at TA=25°C (c)(f)

Linear Derating Factor

1

8

W

mW/°C

Power Dissipation at TA=25°C (d)(f)

Linear Derating Factor

1.13

9

W

mW/°C

Power Dissipation at TA=25°C (d)(g)

Linear Derating Factor

1.7

13.6

W

mW/°C

Power Dissipation at TA=25°C (e)(g)

Linear Derating Factor

3

24

W

mW/°C

Operating and Storage Temperature Range

-55 to +150

°C

ABSOLUTE MAXIMUM RATINGS.

PARAMETER

SYMBOL

VALUE

UNIT

Junction to Ambient (a)(f)

83.3

°C/W

Junction to Ambient (b)(f)

51

°C/W

Junction to Ambient (c)(f)

125

°C/W

Junction to Ambient (d)(f)

111

°C/W

Junction to Ambient (d)(g)

73.5

°C/W

Junction to Ambient (e)(g)

41.7

°C/W

THERMAL RESISTANCE

Notes

(a) For a dual device surface mounted on 8 sq cm single sided 2oz copper on FR4 PCB, in still air conditions with all exposed pads attached. The

copper area is split down the centre line into two separate areas with one half connected to each half of the dual device.

(b) Measured at t<5 secs for a dual device surface mounted on 8 sq cm single sided 2oz copper on FR4 PCB, in still air conditions with all exposed

pads attached. The copper area is split down the centre line into two separate areas with one half connected to each half of the dual device.

(c) For a dual device surface mounted on 8 sq cm single sided 2oz copper on FR4 PCB, in still air conditions with minimal lead connections only.

(d) For a dual device surface mounted on 10 sq cm single sided 1oz copper on FR4 PCB, in still air conditions with all exposed pads attached

attached. The copper area is split down the centre line into two separate areas with one half connected to each half of the dual device.

(e) For a dual device surface mounted on 85 sq cm single sided 2oz copper on FR4 PCB, in still air conditions with all exposed pads attached

attached. The copper area is split down the centre line into two separate areas with one half connected to each half of the dual device.

(f) For a dual device with one active die.

(g) For dual device with 2 active die running at equal power.

(h) Repetitive rating - pulse width limited by max junction temperature. Refer to Transient Thermal Impedance graph.

(i) The minimum copper dimensions required for mounting are no smaller than the exposed metal pads on the base of the device as shown in the

package dimensions data. The thermal resistance for a dual device mounted on 1.5mm thick FR4 board using minimum copper 1 oz weight, 1mm

wide tracks and one half of the device active is Rth = 250°C/W giving a power rating of Ptot = 500mW.